Add support for E22P-868M30S and E22P-915M30S modules for Ikoka-Nano board

[michal-konopinski]

This pull request adds support for E22P-868M30S and E22P-915M30S LoRa modules
in the MeshCore firmware for the Ikoka-Nano board variant.

The change extends the existing board configuration to allow using
E22P modules operating in 868 MHz and 915 MHz bands without affecting
other supported hardware variants.

No existing functionality is modified for other boards or radio modules.

[scoffer7979]

Everything works correctly. I recommend it and look forward to the continued development of the project.

[weebl2000]

@michal-konopinski Please change your PR to merge into dev, not main.

[weebl2000]

Nice addition — hardware config looks correct. Two suggestions below.

[michal-konopinski]

@michal-konopinski Please change your PR to merge into dev, not main.

Hi @weebl2000 ! I’d be happy to change the base branch to dev, but I don’t see the option on my side (not sure if it’s permissions or my lack of skills). Could you please change it for this PR?

[weebl2000]

@michal-konopinski Please change your PR to merge into dev, not main.

Hi @weebl2000 ! I’d be happy to change the base branch to dev, but I don’t see the option on my side (not sure if it’s permissions or my lack of skills). Could you please change it for this PR?

Perhaps the easiest way to change it is to open a new PR that targets dev. I'm not a maintainer on this repository, so I cannot change it either. 😉

[michal-konopinski]

Opened a new PR targeting dev as suggested. #1937